Martin Catalog QD Bushing JA
- group name
- QD Bushings
- Min Order
- 20 piece
- model
- Martin Catalog QD Bushing JA 1-1/4"
- Delivery clauses under the trade mode
- FOB, CIF
- Acceptable payment methods
- T/T
- update time
- Thu, 06 Jun 2019 17:35:02 GMT
Paramtents
Product QD Bushing JA
Material steel C45
Catalog Martin
Surface Treatment Blackoxided
Packging & Delivery
-
Min Order20 piece
Briefing
QD (quick detachable) bushings are designed for conventional mounting or reverse mounting. These bushings with a hub
Detailed
Martin Catalog QD Bushing JA
Martin Catalog QD Bushing JA
QD(QuickDetached bushing is widely used with QD sprockets, pulleys and sheaves.
Material including Steel C45 and Stainless 304, process according to Martin QD bushing catalogue.
Products surface blackoxided, for long term use.
Every piece of QD bushing is well inspected, make them work perfectly with QD sprockets, pulleys or sheaves.
Factory has a large inventory, most of the QD bushings can ship within 15days.
Product Specifications
Bushing Name: | JA |
Weight: |
0.90Lbs |
Material： | Steel |
Bore： |
finished |
A: | 0.375" |
B: |
1.375" |
D | 2.000" |
E: |
0.688" |
F: | 0.563" |
G: |
0.125" |
L: | 1.000" |
Keyway |
Yes |
SetScrews: | 10-24 |
CapScrews |
3-10x1 |
Installation
1. Be sure the tapered cone surfaces of the busing and the inside of the sprocket hub are clean.
2. Place bushing in sprocket, sheave, pulley or other QD parts.
3. Place cap screws and lock washers loosely in pulling holes. Bushing remains fully expanded to assure sliding fit on shaft.
4. With key on shaft, slide sprocket to desired position on shaft. Be sure heads of cap screws are on outside.
5. Align sprocket. Tighten screws alternately and progressively-until they are pulled up tight. To increase leverage, use wrench or length of pipe. Do not allow sprocket to be drawn in contact with flange of bushing; there should be a gap from 1/8” to 1/4”
Caution:
When mounting screws, apply pressure by hand only. If extreme tightening forces are applied, bursting pressures will be created in the sprocket hub. There should be a gap of 1/8” to 1/4” between the face of the sprocket hub and the flange of the QD bushing. The gap must not be closed. If the gap is closed under normal tightening, the shaft is seriously undersized.
Remove
Contact Information
Contact: Jimmy
Mail: info..........com/jimmy..........com
what app:+86 13588027172
Mobil: +86 13588027172
wechat:zjsprocket
Facebook: smartbhz..........com